Questions & Answers for: Chevrolet 98 degrees

98 to torque the head bolts to 22 ft lbs and than the short bolts 45 degrees, medium 55 and long 65 degrees Those bolts are "Torque To Yield" bolts. You should be using new head bolts, tighten them to

...change How does someone change the headlight bulbs or remove the entire headlight assembly on a 98 Chev K1500 pickup. Thx there should be two rods about 4" long with a 90 degree bend on the top

...degrees), the vehicle will not produce good heat, not enough to keep you warm in the vehicle. Thinking its a thermastat? Need some help. t-stat may be stuck open or may have been removed by previous ...

...98 chevy truck.....I can see the wire behind the glove box when I take it out, but there is no connector...... 4.3 vortec... there is no esc wire on a vortec. the distributor is set to zero degrees. ...

...to 0 degrees and plug the connector back in. this is the same for all GM full size trucks 88-94 94-98 connector is located in the passenger compartment usually under the dash on the passenger

...torque sequence 99 chevy malibu v6 3.1 engine, head bolt torque is-- 98 through 2001 is step1- 37 foot lbs, step 2- rotate an additional 90 degrees (1/4 turn). the rocker arm bolts are 168-in.

...98 chevy 1500 w/t 4.6l wont start, it turns over, i hear the fuel pump working, im getting fuel to the engine, the plugs are firing. My truck has been doing this for years, once every 3-6 months, i ...

where is the power wire i need to remove to change my timing? on a 98 you dont have a wire. you have to put it on a scan tool and time the engine by the cam degree.

...the rear of the steering wheel not slots...The 96 through 98 have shroud holes which are available when  the wheel is turned 90 degrees then 180...Make sure you disarm the air ...

Why is there no heat in my 98 chevy Silverado? replaced thermostat The heat control opens a valve at the firewall typically found on the passenger side behind the glove box. If the rod connecting the ...