Questions & Answers for: 93 ford ranger plug wire

Question about 1988 Ranger

1 Answer

...ford ranger 2.3L 2x4 with a new block the truck sat for a long time both w/ and w/out the new block. I took it to a guy who got it fired for me but the rodents trashed the wiring. I am looking to put ...

Ad

Question about 1993 Ranger SuperCab

1 Answer

...Ford Ranger 4.0 V6-5speed, being i was not the one to take it off, i am not sure about the 2 wires on the top. There are 2 bolts not sure what wire goes where. Thanks for your help Here's 95 Ranger ...

Ad

Question about 1993 Ranger SuperCab

1 Answer

...93 ford ranger 2.3 liter manual keeps spitting and sputering while driving on the high way this happens while in 4 and 5 gear whats is wrong I'd spend the money to change plugs & wires & cap ...

...93 ranger fit in my 86 with a 2.3 four cyl ranger you will need to change engine and transmission along with the engine wiring harness and computer also if your 2.3 was carburetorated you will need ...

93 ford ranger 4wd shift motor new, push button switch is good.. lacking power to motor and switch is lit up all the time and so is dash saying its in 4wd had the same problem with my explorer check ...

Question about 1997 Ranger SuperCab

1 Answer

...ford ranger Changing the spark plugs is a pretty easy task. The spark plugs run along both sides of the engine (if its a V block) , 1 per cylinder. You can easily identify them by the plug wires ...

Question about 1993 Ranger SuperCab

1 Answer

Need diagram for distributor cap and spark plug wires to a 93 ford ranger 3.0. Any helpwould be appreciated 1993 Ford Ranger 3.0 liter V-6 VIN "U" Hope helps (remember rated and comment this).

...ranger want start You may have got the spark plug wires out of sequence. Reseat the coil wire going to the center of the distributor cap Check the spark plug wires at the distributor against the ...

93 ford ranger will not start even after changing pugs and wires. put new solenoid switch and fuel filter and spark plugs and wires on will not turn over the wires are correctly put on distributor ...

...93 Ford Ranger 3.0 missing when hot. I have replaced the timing belt, plugs, wires, distributer cap, and rotor button. Compression good on all 6 cylinders when the engine is hot ? If yes, it could be ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...