Questions & Answers for: 8n

Ford 8n gets hot, may need to be timed,Step by step needed. I have a Ford 8n, it gets hot after about 2o minutes of use. Have replace everything but the whole tractor,I was told it was the timing.Have

Replacing 8N starter motor I have an 8N and replacing the starter motor. I cannot get the starter motor back into the housing. What is the trick to this? Sheri IT helps to loosen the oil canister ...

The steering column shaft in my 1954 Ford 8N tractor broke and I need info on howe to fix it. Not sure, but if it's a 1954 model, it's not an 8N. 8N was only built thru 1952. But sounds like you will ...

need a diagram of the brake system on an ford 8n tractor If it was mine, I would buy a service manual for it. You didn't mention the year but the link below will take you to the eBay listing for ...

I have a ford 8n tractor. Change the sparks plugs , condenser, and point and gap them. I have spark now, but will not start. There is gas goin in the carb. It gettin to be a headache , can any one ...

what is the point gap ford 8n .015 for 2N, 8N & 9N The 8N also had problems with ignition switch causing several troubles, cheap and easy to replace....Below link is an excellent ...

what is the point gap for ford 8n The point gap on the 8N is 0.015".

what is the point gap for a 1948 8n ford tractor The ignition point gap is 0.015" and the spark plug gap is 0.025". More specs here: http://www.tractordata.com/farm-tractors/000/2/2/223-ford-8n-engine

Cannot turn distributor by hand on a 1950 ford 8n I am trying to time my ford 8n but the distributor won't turn by hand. I did loosen the hold down clamp. It is frozen, hit it with a soft faced hammer

Converting a '34 8N to 12v negative ground from 6v pos ground. Trouble with the solenoid. New 12 v tractor solenoid but can't make it work. Which terminal should the red/blue neg wire from the foot ...