Questions & Answers for: Buick LeSabre 6 screwdriver

those wires back to the coil that is bad. or you could also have someone crank it while you stick a screwdriver in the end of the wire on the plug and hold the screwdriver next to the engine or a good

Ad

Question about 1998 LeSabre

1 Answer

...ignition key forward and nothing from the starter. I turn the ignition on and was able to do the screwdriver trick on the starter to get it to turn over. It started and ran for about three seconds ...

Ad

Question about 2002 LeSabre

1 Answer

...buick lesabre Hi. Remove the retaining screws from the license plate light assembly with a Phillips screwdriver. There are two screws on each side of the lens assembly. Pull the light assembly cover ...

Question about 1993 LeSabre

1 Answer

...troubleshoot? Try this: with car in park or neutral and parking brake on, get under starter with a screwdriver and short the solenoid terminal with the big red wire to the smaller terminal (not the ...

Question about 1993 LeSabre

3 Answers

...engine/transmission there is a plastic cover, remove it, have a helper hold a large straight slot screwdriver in a tooth on the flywheel. If you have a impact wrench that will work to. Remove the ...

Question about 2000 LeSabre

1 Answer

...the past 25 years and i have a very refined technique.You need a 24 oz hammer and a large standard screwdriver or flat tipped prybar.Do exactly what I say.the seal is shapped like a top hat.The lip ...

Question about 2003 LeSabre

1 Answer

the top of the park brake arm, under the dash. Its small, 1.5 to 2 inches long. I recommend using a screwdriver to "flip It", keeping your fingers and hand and your face for that matter, away from the

...it isn't nearly as difficult as I had researched. It turns out all I had to do was take a flat screwdriver underneath the car to reach the latch from behind the radiator. First take the grill

...the battery. Remove the four screws securing the driver's side kick panel, using a Phillips screwdriver. Use a slotted screwdriver to pry out the kick panel. Remove the passenger's side ...

Question about 1997 LeSabre

1 Answer

replacing water pump What tools to use Just a standard metric socket set a 10mm wrench, flat screwdriver( to place between two of the bolt heads to hold pump pulley in place so you can loosen bolts) ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Buick LeSabre
2000 Buick LeSabre

1,731 Questions

1997 Buick LeSabre
1997 Buick LeSabre

1,603 Questions

1995 Buick LeSabre
1995 Buick LeSabre

1,084 Questions

1994 Buick LeSabre
1994 Buick LeSabre

904 Questions

1998 Buick LeSabre
1998 Buick LeSabre

897 Questions

Manuals & User Guides

Loading...