...to remove plug on side of engine behind exhaust manifold for you to time the oil pump with a small screwdriver insert screwdriver through the plug hole while turning the oil pump gear screwdriver ...
Question about WD-62525 62" Rear Projection HDTV
...cartridge, part number 915P020010, call (800) 553-7278. To replace the lamp, you need a Phillips screwdriver. Turn the television off and unplug the AC cord. Remove the front speaker grill by ...
...my rear speakers but the speaker is held in place by screws that I cannot reach with a regular screwdriver. Is there some type of name for the screw driver I'm supposed to be using? I have no ...
Question about WD-60735 Projection Television
...compartment, located on the back of the TV. Refer to figures 1 and 2. Use a #2 (large) Phillips screwdriver to loosen the screw securing the cover. Keep the screw and cover for re-installation 3. ...
...the front speaker grill by gently pulling on each side. The grill will snap out. 3.Using a Phillips screwdriver,remove the three screws that hold the recessed plastic cover in place. 4.Remove the ...
...flick the ignition key until you feel or hear compression pushing against your finger. then get a screwdriver or similar and put into plug hole, then ask freind to slowly turn the crank with a ...
...from the HC100 projector 1. Reverse the projector gently. 2. Loosen the screw (a) using a Phillips screwdriver (+), and remove the lamp cover (b). 3. Loosen the screws (c) using a Phillips ...
how to change lamp on wd62525 Tools needed: Phillips screwdriver 1.Turn the television off and un plug the AC cord.2.Remove the front speaker grillby gently pulling on each side. The grill will snap ...
...and work the lock to make sure it is free. if that doesn't work take a small screwdriver and push it into the latch an the lid. If it catches the screwdriver then the latch ...
...over. Maybe you mean it won't start. First, remove a ignition wire from the spark plug and place a screwdriver in the end of the wire. Hold the screwdriver close (almost touching) to a metal part of ...
Usually answered in minutes!
997 Questions
851 Questions
799 Questions
747 Questions
704 Questions