Question about Memory Craft 9000 Computerized Sewing Machine
...Manual sliding is not working for me. But I can unscrew the plate and lift the feed dogs with the screwdriver and it seems to run okay (until they drop again - then I still have to lift with the ...
Question about Memory Craft 9000 Computerized Sewing Machine
...to replace the entire needle shank when a needle breaks. The Embellisher comes with two alan key screwdrivers for changing needles. Insert the larger screwdriver at the red marking to loosen the ...
...case, usually at the 6 oclock position when the case is in the machine. There should be a small screwdriver in your kit. Turn the tension screw 1/2 turn and try it. No luck, try another 1/2 turn. ...
...case out, look for the little red dot on top of case--under that is a small screw--get a very small screwdriver and adjust----CAREFUL-IT JUST TAKES A VERY, VERY SMALL TURN--JUST ...
Question about Jem Gold 660 Sewing Machine Compact and portable
...budge. Hello, There is a screw that is pretty hard to get to. I suggest using a Philips screwdriver that is magnetized. When you remove the large wheel on the right side of the cover,
Question about Memory Craft 9000 Computerized Sewing Machine
how do you tighten the bobbin case Hai, Please take one small screwdriver and tighten the bobbin case upper small screw. Otherwise take the one empty bobbin tighten the bobbin case. After check the ...
Question about Memory Craft MC 9700 Sewing and Embroidery Machine
...Many of these use a small button to release the covers or a screw that can be removed with a screwdriver to gain
Question about Memory Craft MC 9700 Sewing and Embroidery Machine
...the needle plate, and bobbin case. On the front, you'll see a small screw . Using an eyeglasses screwdriver, turn the screw 1/4 turn to the left; never turn it further than 1/4 turn. Put it all ...
Question about Memory Craft 9500 Computerized Sewing Machine
...plastic piece which is attached to the spring doesn't move at all with the bar. I tried putting a screwdriver in between this channel to flag the sensor and that didn't make the message go away. ...
Question about Memory Craft 9500 Computerized Sewing Machine
...oil to the dog mechanism don't put your fingers near them as they may snap back, but use a small screwdriver to give them a tap and see if they move...hope this helps...good
Usually answered in minutes!
565 Questions
193 Questions
102 Questions
90 Questions
79 Questions