Questions & Answers for: Emerson 6 screwdriver

...If that doesn't work then you have option #2. 2 - If #1 doesn't work you can use a small flat blade screwdriver that has been modified with a slot cut into the center of the blade end to bypass the ...

...the unit from the mains power) very important that you disconnect it!....next take a phillips screwdriver and undo all the screw to open the unit...the first the you should see is the black

...to remove the inner door panel that goes around the perimeter of the glass. You can use a small screwdriver to carefully pry the plastic up and work your way slowly around the perimiter of the ...

...very carefully use a standard T-20/25 bit adapter to get the screw loosened. Use a small flat blade screwdriver that has been modified with a slot cut into the center of the blade end to bypass the ...

...bottom of the stainless steel panel in back have a hexagon head that I can't remove. What type of screwdriver do I need? I want to try and replace the fuse because it is completely dead. Thank you, ...

Torx fasteners on back panel have pins in the centers. Thus, Torx bit will not fit into the fasteners. Please advise how to remove back panel, given above info. Thanks. The torx screws were used so ...

...located, follow the wire to the circuit board, look for a silver rectangular capacitor and short a screwdriver over the 2 points to remove any remainder of voltage. There should a small fuse clipped ...

...the funny shaped screws on microwave i can remove the regular screws but not the ones preventing a screwdriver from going inside then. ANTI-TAMPER SCREWS If your model has anti-tamper screws, you

...Some microwaves have an access door on the outside near where the bulb is at. You may require a

...off the back cover, and inside there is a circuit board for the CD player. Get a small phillips screwdriver and take off the bottom of it. Then after that there are a couple motors, look at all