...chuck. it went in smooth and when i went to reverse the get the bit out of there it wont budge. Try using the low torque setting on the drill when reversing and something to assist you getting a ...
...wont come off you will need to hit the chuck with a hammer while you are holding the trigger. if you have a bit stuck in the chuck and cant get it out put the chuck in the vice and hit it very hard ...
Question about Tools 18V 1/2" Lxt Lithium - Ion Hammer Driver - Drill Kit - BHP451
in a vice . you will need to squeeze it very tight. then put the drill in reverse and pull the trigger.if i wont come off you will need to hit the chuck with a hammer while you are holding the trigger
Question about BD12PSK 12-Volt Smart Select Drill
...is stuck. chuck wont open. turns but makes a bit is stuck. chuck wont open. turns but makes a clicking noise the chuck is broken inside if clicking. Ace and True Value stores sell chuck ...
Question about DC920KA Heavy Duty Xrp 18V Cordless Drill/Driver
chuck wont come off dewalt cordless drill 18v xrp my chuck bolt insid of the chuck wont come out and i need to know if it is reverse thred or not i cant say 100% sure for that drill but im betting its
There is a bit stuck in it and it wont even budge . I think the chuck is pooched but the drill is hardly used . Does anyone have any ideas how to fix this ? Use a pipe wrench to turn the chuck open. J
Question about Factory-Reconditioned ZRR9001 18 Volt 3/8-inch Drill/9.6 Volt Screwdriver Combo
...chuck wont tighten when i place the piece inside the chuck i try to turn it but it wont! Sometimes the chucks jam when opened all the way. A firm hand and a quick **** of the chuck sleve will release ...
Question about Factory-Reconditioned ZRR9001 18 Volt 3/8-inch Drill/9.6 Volt Screwdriver Combo
...wont allow me to push the chuck down the sds bit snapped inside the chuck,but i cant get the chuck to pieces to get it out.anyone had this problem before?...the drill is a makita bhr200 You have to ...
bosch 11236vs drill bit wont lock in chuck drill bit wont lock into the chuck, just falls out Chuck mechnism went bad or is dirty.
Question about DC740KA Battery 1500mAh, 12V, Ni-Cd
chuck has opened to max and wont close If it is a reversible drill there is almost certainly a left-handed thread screw or allen bolt through the centre of the chuck into the drill shaft and this must
Usually answered in minutes!
227 Questions
165 Questions
160 Questions
104 Questions