...spider" assembly under the plastic intake plenem. the fuel is delivered to the injector assembly the injectors are actually "poppets" on the end of plastic tubing that are fed through a fuel ...
spider,it houses the injectors or what is called poppets on this sys,they have problems with becoming plugged with carbon and causing a missfire,you can attempt to clean them but that usually does not
...injector popets. If you have to take off the upper intake again, replace the regulater on the spider assy. since your in there. and look for strong spark at the plug, the type of spark that jumps at ...
...spider injectors but will not start I had a 2000 chevy Blazer that had the same problem. I ended up replacing the spider injectors from the local parts house and solved my problem. The computer was ...
...injector and a "spider" of nylon tubes from the central injector to each intake port. It is common for these spiders to break, causing fuel to leak into the inside of the manifold, and cause problems ...
Question about 1996 Blazer
...is the fuel pressure with key on and engine off? since you mentioned spider injector assembly it has to be a vortec engine that requires 55psi to open the poppet valve in the injectors just to
...spider injector assembly. I've also checked the lines from the spider injector to the vapor canister and fuel tank and they're all clear so I'm getting fuel to the spider ...
injector spider. Try to check under the hood in a good dark place and see if you see any arcing with the wires. The spider is a little harder to check since you need to pull the upper plenum to get to
Question about 1998 Chevy Express 2500 Van Lower Intake Manifold for V8 5.7L 350ci
...chevy 4X4 5.7 2500 good fuel pressure but wont stay running sounds like the same problem im having. starts and quits. gas is running back to fuel tank instead of holding pressure in the spider ...
Question about 1998 Chevy Express 2500 Van Lower Intake Manifold for V8 5.7L 350ci
...spider is one injector that supplies six small lines going to the cylinders instead of having one injector for each cylinder. I would ask for a partial refund for parts and/or labor on the fuel pump ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions