...order to remove the cylinder head you need to pull the timeing chain sprockets off with the chain their is no master link in the chain...make shure u line up the timing marks before u pull it off so ...
Lancer The 4G63 (2.0L) engine is an in-line four-cylinder engine. The cylinder numbers are assigned as 1-2-3-4 from the front of the engine (timing belt side). This engine.s firing order is 1, 3, 4, 2
...be greatly appreciated That is probably because of a too rich mixture on start. I don't think that cylinders are flooded overnight, that would be unusual. To ensure you can remove spark plugs ...
ORDER MY PART AT A ACTUAL DEALERSHIP AND THEY SAY THAT THERE IS TWO PARTS THER IS A KEY IGNITION SWITCH AND A CYLINDER IGNITION SWITCH I DONT WANT TO GET THE WORNG PART SO I NEED SOME ASSISTANCE...THE
...cylinder at the Top Dead Center (TDC) mark and align the timing marks. Unhook the negative cable from the battery on the right side of the engine compartment, as you face the engine. Use a wrench to ...
...cylinder head bolts for mitsubishi lancer 2002 Try this I dont know which engine you have. 420a 1. Torque all center bolts to 25 ft-lbs, torque the 4 corner bolts to 25 ft-lbs 2. Torque all center ...
Question about 2005 Lancer
cylinder at the front of the engine is #1. Followed by #'s 2, 3, and 4 all in order. The firing order is 1-3-4-2, but that is only the order that they fire in, not there location. So #2 is the 2nd
...order to check to see if you have a bad wire, switch the wire with another cylinder's wire and see if you have current there. Newer cars now have independent coils to each cylinder and it would be ...
...order and do not neglect to clean the rust off the caliper mount on the other wheel also. ther are two ways that calipers stick #1 hydraulics fluid comes from the master cylinder as the pedal is ...
Usually answered in minutes!
997 Questions
654 Questions
213 Questions
209 Questions
136 Questions