How do I remove the cover to replace the motor belt? There are 3 screws across the back of the cover and then there are 2 more screws located on the bottom side of the cover. You will need to fold the
I am trying to take the motor cover off to replace the motor belt. I have removed the screws in the back panel, but the cover still appears to be in a bind and I cannot find any other attatchments in ...
...cover on Epic 550 treadmill. I have removed 4 - 3/4" screws from front panel and 2 - 1/2" screws from underneath. Still feels locked on. Are there other screws to remove somewhere else? If ...
Everything works on the display but when you start the track it doesn't move. If you start walking on the track it will dsiplay your speed but not run by itself Remove the front cover and check to
belt and incline wont move. If the console takes batteries, replace them. If this does not work or your console does not require batteries, check the reed switch or optic sensor. Reed Switch: Unplug ...
start at full speed then stops If the calibration does not pass you may need to check the speed sensor alignment. 1) Remove the motor cover hood by loosening the 4 screws that hold it in place (you do
lights track light is out Check this and adjust it:If the console takes batteries, replace them. If this does not work or your console does not require batteries, check the reed switch or optic sensor
how to open the box of the treadmill We want to change the belt but we can't open You have to lift up the back of the treadmill a little to access 2 phillips head screws that keep the motor cover on,
...550 Walking belt needs replacing, how do I get old one off? Heidi, There will be quite a bit of disassembly required to remove belt, I have attached your manual, which shows an exploded view showing ...
Usually answered in minutes!
122 Questions
67 Questions
16 Questions
20 Questions
11 Questions