Questions & Answers for: 4wd fuse

4WD HI/Lo? Is so, then check your fuses in the fuse box. You may just have a blown fuse. On this website you find fuse box diagram and description for Oldsmobile Bravada (1998) Oldsmobile Bravada 1998

...01 jimmy in 4wd. The other day it went in 4wd low when i put it in 4wd hi and now that it is back in 2wd i am not able to engage 4wd at all fuse! I bet it is the fuse.does it flash and try to

...4WD Fuse We have a 2001 Silverado that began blowing fuses and the transfer case would go into neutral. Last night it popped 4 fuses and melted 2 paper clips. This does not matter if it is 2WD, 4WD ...

...fuse when i pull 4wd shifter back into 4wd, also even pulled back it doesn't actually go into 4wd. There is an electric actuator on the front axle that engages 4WD. This part commonly fails resulting ...

...when shut truck off 4wd won't work fuse blown out replaced fuse still not working. check the 4wd switch on the transfercase and wiring sounds like its shorting out. Fuses only blow when theres a ...

...a 98 gmc yukon. just had tranny replaced and now it wont switch into 2wd...and if you switch into 4wd low you cant switch out of it unless you remove fuses. put th e fuses back in and it starts off ...

...fuse related to the 4wd that i know of if the 4wd switch doesn't light up to show what mode it is in the tccm will set a code and the 4wd light will be on the fuse is in the under hood fuse block I ...

fuse controls the 4wd actuator. some of those are vacuum controlled the most common place for them to break is just behind the engine at the intake passenger side check there first. another thing that

4wd light do not turn on even the key is turned on. Could be some fuse? some cable or connector loose? I apreciate your comments. Check the relay first then the fuse. If they are not bad then it might

...fuse cause 4wd selector switch not to work? 4wd stopped working after i replaced my alternator, will not try to lock into 4wd, and also the lights on selector switch are not working and when u push ...