Questions & Answers for: Saturn LS t 30

...it start..... My 2000 Saturn LS has a similar problem. After driving for a while, then sitting for 30 minutes or so, it won't start. It will crank over just fine but doesn't start. It has always ...

Ad

Question about 2000 Ls 4dr Sedan

2 Answers

...I don't really need my odometer. Cheap solution: Disconnect your negative battery cable for ~20-30 mins, re-connect it, and see if that fixes it. Some cars' computers go wonky if a KAM (Keep

Ad

...may need to be reset you can try it your self by unhooking the negative cable on the batt for 30 seconds then rehook it to reset the ...

Question about 2000 Ls 4dr Sedan

2 Answers

....how much to fix this problem>?? the labor for the timing cover is 4 hours and the seals are about $30. You can try to tighten the bolts just a little This is an involved job so you may want to ...

Question about 2000 Ls 4dr Sedan

1 Answer

...or cold air, when you turn it on it doesnt engage, sometimes if you hit a bump it comes on for like 30 seconds and when the heat is on yo can feel it in the vents, same with the ac Sounds to me like ...

...where it is located and the fuse number? Below is an image showing that it's fuse #6 and it's a 30 amp fuse. This fuse also powers the chime, fuel system, dome lamps, clock/radio, decklid

Question about 2000 Ls 4dr Sedan

3 Answers

I do not know what type of oil my car takes Maximum Performance Signature Series 0W-30 100% Synthetic Motor Oil (SSOQT) Signature Series 0W-30 100% Synthetic Motor Oil (SSOQT) Drain Interval ...

Question about 2000 Ls 4dr Sedan

1 Answer

put clucthn rear main seal in keeps blowing 30 amp fuse on ign. ? Sounds like you might have pinched a wire somewhere, or that your wires on your starter are either not tight, or possible the smaller ...

...on refrigerant. you can buy a charge kit from your local auto parts store, or walmart for around 30$ just follow the instructions and you should be good. if that doesnt take care of the problem

...cables from the battery and hold the positive cable and the negative cable to each other for about 30 seconds. Doing this drains the capacitor in the ECM and resets the system. Reconnect the cables ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...