Question about 24 in. SGS43C12 Classixx Free-Standing Dishwasher
If I lift up the "mushroom" it usually ends the programme. Any ideas??? The "mushroom" bottom is just a lever that operate a switch. It seems that a part of the switch's mechanism is broken or release
Question about 24 in. SGS43C12 Classixx Free-Standing Dishwasher
...If it is, and the lever on the switch is moving fine aswell then you should check all the wires coming out of the switch, and if they are all connected properly you will prob need a new
...switch. Power cord is good. Maybe the direction lever above the trigger is bad. I hate to keep throwing parts at it. Any thoughts? --Bill If it is an 1199, forget it. Replace the brushes and do NOT ...
...switch. If the lever is broken, the switch would not activate and the dryer would not start. Replace the lever, if broken. Note: Door switch actuator lever usually comes with the door switch assembly ...
Question about Nexxt WTMC3321US Electric Dryer
switch lever can't move compressed air works best to clean it Thank you garing! I just tried your solution on our Bosch WTMC3321 dryer and it worked. After hitting start, I carefully pressed the motor
Question about Nexxt WTMC3321US Electric Dryer
...of lever does not contact to switch. is this due to any safety feature The lever could be in a safety position. Unlock the safety lever to get it in contact with the switch., and squeeze to
Question about Integra 300 Series SHX43C0xUC Built-in Dishwasher
...switch Check the inlet valve filter screens Test the water inlet valve Test the drain valve lever arm Check the drain valve Please check each one of these out carefully ok Hope this is very helpful ...
Question about SHU9925UC Built-in Dishwasher
...switch is a small white lever located on the right side near the water inlet valve. If you remove the toe kick you should be able to wiggle the float lever. They tend to get hung up after sitting for ...
...sideways, the other is on the linkage for the switch. One is larger than the other, the small one is for the switch linkage return and the other is obviously for the handle rotation lock lever. ...
...switch lever can also cause you to have problems. If the lever is broken or bent it will not activate the switch. If the switch is broken, this also will not allow the dryer to be started. The push ...
Usually answered in minutes!
800 Questions
243 Questions
226 Questions
184 Questions
155 Questions