Questions & Answers for: Ford F-250 27 lb

04 f250 6.0 diesel need torque specs on intake manifold there are no torque specs! standard are 30 in pounds ! start from the inside out! The torque specification is 62 in lb

...of the plate. Install the shift handle (7E067) into the control lever assembly (7E069). Tighten the retaining nut to 27-38 Nm (20-28 ft-lb). Check transfer case for proper shifting and

what is the fuel pressure supposed to be. I tested it today and it read 30lb at idle and dropped to 20lb when i reved it up 28-45 when running 35-45 key engine off check your fuel filter for blockage ...

how to change an exhaust manifold leak 7.5L Right-Hand Removal Remove spark plug heat shield (12A406). Remove distributor to spark plug wires (12286) using Spark Plug Wire Remover T74P-6666-A. ...

27-32 lb/ft). Rotate fasteners 1 through 10, 85-95 degrees. Stage 2: Tighten the cross-mounted fasteners 11 through 20 to 27-33 Nm (20-24 lb/ft). Rotate fasteners 11 through 20, 85-95 degrees. Tighten

1995 ford f250 headlight assembly how to remove.it has 2 screws on top and 2 on bottom how do i remove 2 bottom screws REMOVAL AND INSTALLATION Headlamp Assembly Removal Remove radiator air deflector ...

...Nut to 68 Nm (50 Lb-Ft) to Seat Bearings. Back Nut Off 90 Degrees (1/4 Turn). B - Tighten to 217-278 Nm (160-205 Lb-Ft) C - Tighten to 4-6 Nm (35-53 Lb-In) Removal Separate cap assembly from hub ...

...Pin 9 3304 Steering Sector Shaft Arm Drag Link 10 383489 Nut 11 3001 Front Axle Assembly 12 388727 Bolt A - Tighten to 77-103 Nm (57-75 Lb-Ft) B - Tighten to 68-92 Nm (50-67 Lb-Ft) C - Tighten to ...

head bolt torque for a 5.4l ford triton To achieve the recommended torque follow these steps: 1. Lubricate the bolt threads with engine oil 2. Torque them to 30 ft-lb 3. Using a torque angle gauge - ...

what is the torque spec for rear axle nut bearings? Ron, if you are talking about the nut on the end of the hub, it goes as follows. Tighten to 70 lbs-ft, then back nut off 90 degrees, check for side ...