oh and what do i what do i torque my lugnuts to? i can not find my owners manual and have not been able to find the torque setting anywhere else. TORQUE VALUE CHART 7/16" dia. 50 to 60 lb-ft 12mm dia.
no tranny dipstick to be found ANYWHERE!!!!!!!!! It's not there, got another idea. this is a '98 malibu 3.1 litersfi v6. IT IS NOWHERE and i mean nowhere. clues? The fluid level screw is intended to ...
Hi, Hi, 1998 Malibu 3.1L, 103,000 mi I am getting water in the oil. The compression is 150lb in all cyl. I have tested the pressure on the radiator at 18 lb. and I am slowly loosing pressure One lb. ...
where do I find the crank censor on a malibu classic 2005? Crankshaft Position Sensor Removal & Installation 2.2L Engine To Remove: Raise and safely support the vehicle. Starter Remove the starter
What is the wheel torque for my tires? 100 ft-lb's
...27 lb in) 2 Headlamp Assembly Procedure Pull forward on the outside edge of the headlamp in order to release the up and down locator tabs on the backside of the headlamp. Pull forward on the top ...
where is thermostat on my 2005 chevy classic Thermostat Removal & Installation 2.2L Engine 2004-2005 To Remove: Drain the cooling system. Remove the thermostat housing-to-water pump feed pipe ...
torque for lifter on 99 chevy malibu 3.1 35 ft lb
Question about 1999 Malibu
What are the Torque Specs on the Head Bolts for a 1999 Chevy Malibu 3.1 Ltr engine 40 lb-ft and sequence and then a final 90 degree turn on each bolt in sequence. The first answer you got from ...
What are the Torque Specs on the Head Bolts The reference I found was bolts to 40 lb-ft in sequence. I always like to reach the final torque value in 2 or 3 passes to make sure I'm tightening ...
Usually answered in minutes!
1,306 Questions
1,257 Questions
1,094 Questions
1,067 Questions
997 Questions