Questions & Answers for: Chevrolet Blazer 27 lb

knock sensor 95 chevy blazer What would be the tightening instructions be? And would lock-tite be a suitable sealant Use liquid teflon, no LOCTITE! Tighten to around 8-10 ft lb's

Torque for eshaust to manifold in GMC Jimmy 1995 4WD vin W I have a leak from exhaust at joint with manifold; one nut is loose and I want to tighten it. It sounds like a **** and may I don't have to ...

where is the oil sending unit on a 2001 4.3 liter vortec v6 ENGINE OIL PRESSURE SENSOR OR SWITCH REPLACEMENT TOOLS REQUIRED J 41712 Oil Pressure Switch Socket REMOVAL PROCEDURE IMPORTANT: Clean the ...

93 CHEV 4.3 VORTEC. CHANGED SENDING UNIT & PUMP HOWEVER ONLY HAVE 32-40 LB AT GUAGE NOT ENOUGH TO START? OR POSSIBLE INJECTOR PROB??? SPIDER INJECTORS WERE REPLACED 2YRS AGO AND ONLY HAVE 1 MILE ...

whats the torque on a wheel bearing what to set the torque on a front wheel bearing of a 2006 chevy trailblazer 103 lb feet Simple torque for all wheelbearing's is tighten until the wheel wont turn ...

how to install new races without a press? 1988 K5 Blazer 4x4 front. you use a large brass drift punch and a ball pen hammer, tap in with hammer to set, then drive home with brass drift punch, any ...

Torque requirement for a 1999 Chev Blazer front hub assy? Tighten the wheel hub and bearing assembly to the steering knuckle mounting bolts to 105 N·m (77 lb ft).

need to know the readings i should have at the fuel pump 4 pin connector Talked to a local garage guy & he told me 12 v at purple pin (only till it pumped up 60 lb press.) & 5v at gray, other ...

1998 Chev Blazer 4x4 frnt wheel bearing torque setting for nut?? The torque spec for the axle nut is 103 lb ft. The torque for the wheel hub is 95 ft.lbs.Hope this helps.Good luck.

...(1-8) to 3 N·m (27 lb in). Tighten the bolts on the second pass in sequence (1-8) to 12 N·m (106 lb in). Tighten the bolts on the final pass in sequence (1-8) to 15 N·m (11 lb