Questions & Answers for: Oldsmobile 27 lb

1999 Oldsmobile Alero 2.4L. What is the torque in lbs for the head bolts? 75-85 lb

Need cylinder head and intake torque specs on a 1976 oldsmobile 455 1976 OLDSMOBILE TORQUE SPECS 455 CI cylinder head torque 85 ft/lbs 455 CI intake manifold torque 40 ft/lb Hope this helps

27 lb in) .  Install the right side and center lower bolts to the hazard warning switch through the center air louver deflector pocket. Tighten Tighten the left side hazard warning switch bolt to

oil pressure light came on engine is knocking like no oil is getting to engine need to know where oil pump is located and is it hard to fix thanks for your help hi what what engine? if it's knocking ...

hoe do you change spark plugs in a 2001 intrugie Remove the ignition coil assembly than remove the spark plugs, the rear ones will be tighter spot but still doable. Measuge the gap to 0.06in and ...

How do you replace coolant temperature sensor on an 2001 Oldsmobile Intrigue Removal & Installation To Remove: ECT sensor 3.5L engine Disconnect the battery ground cable. Drain the coolant below ...

how to remove front spindle nut on a 2000 Oldsmobile Bravada The 2000 Oldsmobile Bravada spindle nut is 36mm, and the Torque specification is 203 ft-lb. To remove the nut you need a very powerful ...

location of thermostat on 2002 olds alero 2.2 Thermostat Removal & Installation 2.2L Engine To Remove: Remove the exhaust manifold. If equipped with an automatic transmission. Drain the cooling ...

how to replace crankpully on 3300 olbs CustomerThanks for being a justanswer customer Dave *** UPDATED BY TSB #91-T-05 DATE: 9/90 The harmonic balancer on these engines is now press fit onto the ...

Need head bolt torque specs for 1999 Oldsmobile intrigue Ian: According to Chuck on FixYa.com: Head bolts are torque to yeild so you MUST use new bolts. Tighten cylinder head retaining bolts in ...