Questions & Answers for: D-Link 3 4 25

No access to port 25 for wireless clients I have four computers (3 wireless, 1 direct) connected to my D-LINK 614+ router. MY ISP is Optimum Online. Last week, all three computers linked wirelessly to

...for assistance and I'm just staring at my screen. How long do I wait for someone? Its only been 25 min. so the problem is your pc, that can be go in internet. try this command to command prompt ...

...I am limited at a speed of 9.2 to 9.5, if I plug my computer directly into the modem I hit between 25 and 30Mbs. I have updated to the latest firmware available and it still maxes out at 9.5Mbs. ...

...still unable to receive emails Do you have an email server in place? If so, you need to setup port 25 for inbound access to the IP address of the email server. I would suggest that you don't allow ...

...save themselves the pain. In this case, I couldn't send outgoing email via my SMTP server on port 25 despite the fact that I could receive email fine. It all came down to transparent proxying, but ...

wireless drops off after 30 minutes, comes back with reset, then drops off in 25 minutes, and so on. wired internet ok. This is a problem with the firmware of your router since the wired part is ...

...Direct connected on the Motorola surfboard there is no problem. Detailed log: ... 32 21:25:05.140 11/16/09 Sev=Info/4 CM/0x6310000E Established Phase 1 SA. 1 Crypto Active IKE SA, 1 User ...

...so only those I allow can use it. How do I do it? Here is the manual, wireless setup is on page 25: ...

speed on Verizon Fios I just upgraded to 50/25 internet on Fios since sped was mediocore, at best. Still very slowon wirelss. 14mbsp download/ 16mbps upload. I hard wired into my DI-624 router and ran

...client. The Standard port used by POP3 is 110 for incoming mail, Outgoing SMTP server uses Port 25. Make sure your router doesn't have these ports ...