1990 mazda b2200 just replaced the thermostat and took it for a test drive and now the exhaust is billowing out white smoke....the oil is fresh and clear and i don't see any other leaks....pls ...
mazda b2000 clutch slips when warm just had clutch and flywheel replaced. in cold weather- no problem. when it warms up, above 50 f and i drive about 10 min., the clutch starts to slip if i apply a ...
1990 Mazda B2200 PU. Clutch sticks to the floor and if held down eventually allows disk to engage. Can pull it up with side of foot before tries to engage, then works again. No noise from throw-out or
need to know how to do the timing on my 88 mazda b2200 truck To check the timing or replace the timing belt? Well, in any case, It would be to hard to tell and show you over the computer. The best and
20 min starts up ok until another 30 min and stops again spark is ok and fuel pressure seems ok ,engine will crank but seems like its totaly dead then I wait a 15 to 20 min and it runs like brand new.
i need torque specs for the head on a 93 mazda b2200 2.2l 4 cylynder First Step: 20 lb/ft Sec Step: 40 lb/ft 3rd Step: 59-64 lb/ft
...b2200 Disconnected the battery for 30mins and then connected again. un hook the battery for 15-20 min that usually will do it but if you havent fixed it the light will come back on hope this ...
1996 bongo overheating, not the stat rad,headgasket, or hoses but overheats after 30mins driving at 80 k hav checked the stat and even took stat out but still overheat after 45 mins idling, no water ...
speedo fluctuates between 20 & 50 kph above actual speed remove your speedo cable if its in ok shape lubercate it with high temp greese if its not in good shape and it may not be replace it before
i have 1988 madza B 2200 it runs for 20 mins or so and shut down hello, go under it and see if cathalistic gets red, than you might have a clogged cathalistic!
Usually answered in minutes!
738 Questions
692 Questions
544 Questions
609 Questions
615 Questions