Questions & Answers for: 2007 dodge caliber shifting problems

...2007 dodge caiber and it wont shift out of park. it is as if the gears are locked. dont know what happened. it was parked for about 4-5 hours and now when i started it it just wont shift. the handle ...

...2007 dodge caliber. shift lock not releasing and holding it in gear,check fuses,sometimes theres a switch on the brake pedal,that releases it from Park when you put your foot on the brake There is a ...

...I suspect it may be a fuse problem, but do not have an owner's manual or fuse diagram to check the fuse 2007 Dodge Caliber. no it sounds like the linkage on your shifter needs adjusted its out of ...

...2007 Dodge Caliber 4 cyl Front Wheel Drive Automatic 40000 miles I'm thinking it may be a fuel filter problem...when I try to accelerate, especially on an uphill grade, the whole car hesitates or ...

2009 dodge charger my battery light comes on car wont shift wont go past 30 mph I replaced the alternator it was bad charged and checked battery its good started to drive again battery light comes on ...

2007 dodge caliber etc light on when you turn key on the etc electronic throttle control light stays on .The car will not start. Get a can or two of carb & choke or intake cleaner. Take the intake

...2007 Dodge Caliber would not come out of park, and also I had no brake lights. After trying about everything I could, I figured it was just a fuse, so I used the manual release and headed home, The ...

...2007 dodge caliber with a 2.0 engine. Please show me where the output speed sensor is located Why ? Is the checking light on ? Is there a DTC - diagnostic trouble code ? What problem are you have ? ...

...2007 Dodge Caliber and my problem is my car will not go over 25mph the RPM will rev all the way up but the gears will not roll over what do you guys think I should do I’ve already flushed my ...

2007 Dodge Caliber? The Crankshaft Position Sensor is in the rear of the engine block near the transmission. If vehicle is All Wheel Drive the Power Transfer Unit must be removed. The codes do need to