...2005 models, I have one and the front bearings are packed in a hub, you have to remove the wheel, caliper and base and behind the hub theres 3 5/8" bolts, remove them and you will have a complete ...
...Dodge Ram 4x4 (1500) 318 Engine. What is the torque on the front axle hub nut ? Also on the same truck the A/C looses its vaccuum when you accelerate then returns when you level out your speed Ram ...
what are the front axle nut torque specs for a 2005 dodge ram 1500 4x4 185 ft.lbs rear torque spec for 05 dodge ram 1500
i need the touque specs for the outer front axle nut on a 2005 dodge ram 2500 4x4 HUB AND BEARING ASSEMBLY NUTS TORQUE TO 125 FT LBS THE HALF SHAFT AXLE TORQUE TO 185 FT LBS.
...spindle hub nut 97 ft-lbs • lug nuts 100 ft-lbs. 185 ft lbs and here are the instructions to do it. ...
...2005 dodge dakota 4x4 and need the torque setting for the 3 hub bolts on the front end also the axle nut torque setting The torque for the hub bolts is 120 ft. lbs The torque for the axle nut is 185 ...
Question about 2001 Ram 1500 Truck 2WD
What is torque procedure for front wheel hub with lock nut, no cotter pin? 2001 Dakota 2WD (same basic setup as the 1500) calls for 185 ft lbs/251 N m. Must use NEW self locking nut.
Question about 2001 Ram 1500 Truck 2WD
...are lock nuts on axle, not nuts with cotter pins. Axle's do not have cotter pin holes. 2001 Dodge Ram Truck Service Repair Manual INSTANT DOWNLOAD My problem was easily solved. I hope your too
Question about 2001 Ram 1500 Truck 2WD
torque specs for 2005 dodge ram front wheel bearing hub - 3 bolts I need more info. Is this a 1500--2500--3500, 4wd or 2wd?
Question about 2001 Ram 1500 Truck 2WD
...on a 2003 Dodge ram 1500 need Wheel Bearing and Hub Assembly - Front (MPA WH515006) Wheel Hub Assembly Axle Nut Torque Spec: 180 ft-lbs / 244Nm, tighten further to align cotter pin with hole.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
