Questions & Answers for: 2003 honda pilot ignition switch

...2003 honda pilot maintenance required light flashes 10 time before i star it,i change the oil already and still flashing.. can anybody help me with that pls.. to reset the the light , turn ignition ...

...2003 Honda Pilot. Was given code to disengage immobilizer so car will start and drive to dealer to program keys to car. How many times will this work or is it once and what is the procedure for ...

...2003 Honda Pilot. I have three keys - none work. I need to get it to a mechanic but I'm looking at a pretty hefty towing charge as it happened out of town (of course). Is there another solution for ...

Honda Pilot. The new key works in the door but not in the ignition. Thinking it needs a new ignition switch. Any ideas on cost or a solution? If the key fits mechanically, and the lock turns, then the

...2003 Pilot. The key wasn't consistently turning, but when it did the car started. I replaced the ignition switch. The key turns, starter motor runs, but the engine doesn't run. As far as I know, all ...

put a new ignition switch in my 03 pilot engine turns over now but it wont fire did u get new keys along with the ignition? if yes, then ur new keys have to be programmed again. Only dealer can do it.

...honda pilot that my ex has thrashed the ignition key hole and all pertaining elctrical to and thre my chip keys away, is there any way in hell to bypass it all to start vehicle? you may need to ...

honda jazz ignition barrel won't turn will most likely need the ignition switch replaced its cheaper to have a locksmith repin it but there are other moving parts that wear out also so its best to ...

...2003 Honda pilot Reset oil service light Honda Pilot. From years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012. How do you reset oil service light Honda Pilot. From years: 2003, 2004, ...

...2003 Honda pilot 1- turn off the engine. 2- press and hold the select/Reset button on the instrument panel, then turn on the ignition switch ON (II) 3- Hold the button for approximately ten seconds ...