Questions & Answers for: Mitsubishi Diamante 2003 start cold

...cold start. Turn the ignition to the acc position for 20 seconds and then turn back off. 3.start the engine with no accessories on and let the engine idle from cold to normal temp for 15 minutes. 4. ...

...start. It is a 2003 Mitsubishi Diamante VR-X. I love my car but It just does not want to start when it is wet...Can you put some insight on the problem its your distributer cap, have someone look at ...

My 2003 Mitsubishi Diamante has started to lock itself once I unlock it. Even with the key and not the remote there are times when I can't get the door open quick enough before the car locks itself ...

...2003 mitsubishi diamante will crank but it wont start Lots of possible answers to this but it all falls down to this basic rule with witch to always check these problems. You need three things for a ...

...start cold,but had to sit awhile,then,it wouldn't start at all,help. Starter fails,would start cold,but had to sit awhile,then,it wouldn't start at all,help. Is your battery ...

2003 Starting problems on very cold mornings. The engine will start but immediately die unless accelerator held down. Even if held down, as soon as foot is lifted, engine dies. Only way to keep enging

...2003 and its start for 2 seconds then stops you must make TUNE UP, to due that some component can be faulty, coil, spark plug(short), cables, etc PCM or ECC see the diagram attached. God bless ...

2003 mitsubishi ac air feel cold but it doesnt blow out even though it sounds like the blower motor is working properly Why does my 2003 Mitsubishi ac air feel cold but it doesn't blow out even though

does 2003 mitsubishi diamante have an inertia switch shuts off after starting It does not.

does 2003 mitsubishi diamante have inertia switch was in accident. starts but immediatly shuts off inertia switch Mitsubishi Forum Mitsubishi Enthusiast Forums I would join this forum and add your ...