...2003 Mercedes C180 with 59k on clock. When starting off from cold the autogear box stays in 2nd gear. I turn off and restart and the problem goes. No ''malfunction'' is displayed on screen. I got the ...
Question about 1994 C-Class
...start immediatly after cutting out. On a cold engine, the engine idle speed is approximately 700 rpm - the same as when the engine is warm (Is it supposed to idle higher with a cold engine?) The car ...
2003 e500 does not blow cold air. Fan is OK and the right side ac is OK. 2. Shortly after starting car the engine stops. The engine will turn over but I have to wait for 30 sec to 1 min before it will
...2003) just started a clicking noise from the middle of the dashboard, it start when you turn the car on and goes for about 90 seconds then stops. It doesn't matter if the car is hot or cold. Help ...
Question about 2002 M-Class
...2003 Order No.: T-B-83.40/66 Supersedes: Group: 83 SUBJECT: Model 163.154/157/172/174/175, as of A289565 Air Conditioning System Does Not Produce Cold/Warm Air On the above models, if you receive ...
...2003 starting problems Vehicle hesitates during startup whether hot or cold It happen the same to in my truck it was the starter and alternator When was last healthy tune up? You didn't mention ...
Question about 2003 S500
...18 years not had a bit problem with it i would check the few points i have listed above before spending any money hope this helps ivan When it's cold my 2003 Mercedes Benz s500 w/not start ...
Question about 2003 C-Class
cold mornings (0-2 C) don't want to start. everything works, lights are on, dash is on but engine don't start. i have replaced the battery yeste I have a c200 cdi mb from 2006 (w203 model). in
...cold), you should also check the coolant level in the radiator. Thi sis especially important if the reservoir was low or empty. Open the cap and start the engine, with the heat set to hot and fan to ...
...2003 NOT IDLING PROPERLY WHEN START test coil packs plugs leads has it recently been serviced the plugs must have the correct gap or it wont fire properly usually 1mm gap alos try spraying wd40 onto ...
Usually answered in minutes!
630 Questions
563 Questions
615 Questions
474 Questions
420 Questions