Question about 2005 PT Cruiser
...pt cruiser? Where is the crank sensor located on 2005 chrysler pt cruiser? the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or
...2001 pt cruiser need to find where the crank sensor is located 4cyl It is located next to crankshaft. Just follow spark plug wires to coil pack and module. Then follow from there and they lead ...
2001 pt cruiser car died while driving. threw code 320. replaced crank sensor,cam sensor, and coil pack. it still won't start.any suggestions? Check for spark and fuel. Is it a Chrysler 2001 PT ...
2001 pt cruiser motor will go in 2005 pt cruiser i just put the motor in the car but i notice the crank shaft sensor was on the back side of motor near altanotor i extende the wires to reach but i don
...sencor on a 01 pt cruzer the crank sensor is located in the transmission bell housing where the trans bolts to the engine block.its held in by one bolt and is a 2 wire round plug connector i
Question about 2001 PT Cruiser
2001 pt cruiser was diving down the road and just shut off will not start If it turns over (cranks) but does not start, it is almost surly a bad crank sensor. Check to see if your tachometer moves ...
2001 pt cruiser wont stay running without conking out i replaced the pvc valve,crank sensor and cam shaft snnsor and it ran like a scalded dawg for about a week and then it started conling out on me ...
Question about 2001 PT Cruiser
...pt cruiser has code 1391. i changed cam sensor crank sensor wires plugs and coil still getting 1391 code and from 0 mph to 20 mph car skips and revs up any ideas? pt cruiser has code 1391. i have ...
Question about 2001 PT Cruiser
2001 pt cruiser has been in the shop multiple times.bringing up code P1391 & P0352. It bucks hard engine light comes on it stalls out. what can it be?I work out of homes and need to transport. 3 cam ...
Question about 2001 PT Cruiser
2001 pt cruiser starts ,runs for 15 mins shuts off wont start for maybe an hour then does same thing Ignition control module (ICM) or also maybe the crank position sensor. If one of them went bad, it ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions