Questions & Answers for: 2000 suzuki intruder vl 1500

...starter relay? This is main system fuse and not in the fuse panel with the other sub-system fuses. Get your multimeter out, and test the wires going to and coming from your ignition switch. IF your ...

starter relay hot wire only works when bipassed starter relay hot wire only works when bipassed directly to batt terminal needs a new wire or the lugs might have a lot of corrosion but i would still ...

...STARTER IT SELF, BUT COULD BE THE RELAY, USE VOLT METER TO MAKE SURE YOU ARE GETTING GOOD VOLTAGE TO THE STARTER WHEN YOU TRY TO CRANK. IF YOU HAGE GOOD VOLTAGE, AT LEAST 10.5 , THEN IT IS STARTER. ...

...2000 1500 intruder suzuki need help thanks Take a voltmeter and check the armature. You should have continuity between every other contact that the brushes hit. You should not have continuity between ...

...1500 intruder? I found and checked all the the 10 and 15a fuses and all are ok. I just don't find the 30a fuse the manual talks about? Can you help? God Bless, Denis On the LH side of the bike, ...

2000 Suzuki VL 1500 Intruder LC starter solenoid test how to test a starter relay solenoid on a 1500 Suzuki intruder @ Same problem here Buy a clymer manual for that model. It xplains all parts n test

...starter relay, starter still turns over why? Have you checked the starter switch? It could be that it's sticking on after you let it go. A quick check with a multimeter should tell you. I assume that ...

where is starter relay for 2000 suzuki intruder 1500cc motorcycle under the cover left side by the seat it has a spare fuse on one side of it sould be 30 amp fuses

2000 Suzuki intruder VL1500 battery over 12 volts but no lights or power completely dead Hi, Louis and the usual suspects are: 1. Ignition Switch not in the "ON" position. 2. Engine Run Switch in the