Questions & Answers for: 2000 jeep grand cherokee cv

2000 Jeep Grand Cherokee Limited with the v8. When on the highway at about 45-50 mph I get a clunking type noise, but only when applying power. If I let off the gas it stops. Both front axle cv shafts

...2000 jeep grand cherokee and i think the cv joint is gone. the cv joint has grease all over it like it exploded and it only makes the clicking sound every other day if not at all. i have pick. can ...

jeep. Only happens when moving. Sometimes not noticable at higher speeds. Does not start until about 25 mph. sounds like cv axle joint problem chk it out and let me know through another post hope this

need rubber boots on front axle 2000 Jeep Grand Cherokee with 4.0L or 4.7L same part. Constant Velocity (CV) joint boot kit front axle shaft left or right outer part # 686115 this is a NAPA part #.

...cv joint Use a vise,to put the axle in,and pull,holding pressure on the knuckle(cv)and hit it with a hammer pretty hard,there is a snap ring that will be holding it in,and this will allow the axle to ...

...cv joint breaks cv joints in the front axles are clacking on slow sharp turns if they break you will not be able to drive the jeep and when they break they can cause more damage if you are driving ...

...2000 Grand Cherokee with Quadra-Trac I don't remember what the cut-off year was when Jeep changed from standard universal joints to C/V joints but your problem sounds a lot like a bad end joint on a ...

truck is making a clicking noise when i turn the ignition If it's 4x4 its probably the cv joints in the front axle.

...JEEP GRAND CHEROKEE did your read that chapter in the FSM. WJ jeep ? http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service as they say, RTM then ask questions. ask for the whole ...

...cv (constant velocity) joint problem.. If so, you'll most likely need to take it to a shop. The cv joints are the joints in the drive axles coming out the side of your trans-axle and going to the ...