Questions & Answers for: 2000 chevy silverado thermostat location

...2000 silverado 4.3 engin where is the thermostat located ? Follow your Upper Radiator Hose to the Motor. It will Connect to a Bell Housing that is Mounted on the Top of the Block. Remove this Bell ...

...2000 chevy blazer 4x4 4.3 vortec where is the purge solenoid on a 2000 chevy silverado which vehicle are you actually looking for the purge solenoid on? you have 2 vehicles listed in your question. ...

chevy silverado 1500 Where can I find the thermostat on an 01 chevy silverado 1500 pickup? The thermostat is in the hose on the passener side of the waterpump.It is in the part that has the three 10mm

2000 chevy silverado normal operating temp 210 , recently temp rises to 250. water pumps no leaks therm. appears OK . With the truck running at operating temperature, squeeze your upper radiator hose.

2000 Chevy Silverado 1500 The heater does not 2000 Chevy Silverado 1500 The heater does not blow warm air, the ac works fine. I will be flushing the system later this week. I'm trying to locate the ...

...2000 2 wheel drive chevy silverado? And how do i get to it? Thermostats are located inbetween the engine and the radiator. Most of the time there is the top radiator hose coming off of where the ...

...2000, 1500 silverado v-8 2wd 5.3 liter engine located above the a/c pump, below the idler pulley, Drain coolant, remove radiator hose from water outlet, remove bolts, remove thermostat, for ...

...2000 Chevy Silverado I am getting very little heat from the heater. What could be the problem? It could be low on coolant or a bad or stuck thermostat. This thermostat is usually located internally ...

...2000 chev silverado Please see my tip at http://www.fixya.com/cars/r5929960-s_thermostat . These are generic instructions. Locations for Silverado enmgines are shown below. Please get back to me if ...

...on a 2000 chevy silverado vortec 5.3. I'm trying to locate the knock sensor on a 2000 chevy silverado vortec 5.3. It is located in the valley between the cylinder heads under the intake