Questions & Answers for: Oldsmobile Cutlass Ciera 1 6 crank pulley

...crank pulley rib side around p/s pulley to alt pulley flat side on the left side of water pump  then rib side around ac pulley flat side around ...

...how hard is it to replacing the crank shaft pulley Not too hard if you have a pulley puller. Remove the belt, remove the crank shaft bolt, pull the crank pulley off, then reinstall in reverse

...crank pulley. Spin your alternator pulley and listen to it. It should be silent and smoothe. If you hear any bearing noise from the tensioner, the alternator, the AC comppresor, I would do this soon, ...

with no problem. It's the main pulley on the engine. It has a big bolt at the center that holds the pulley onto the crank, that bolt needs to come off. Then the pulley (harmonic balancer) can come off

...luck. what color are the wires that would help me to determine which plug it is. the crank sensor is down next to the crankshaft pulley. also right under the powersteering pump is the camshaft

have to turn the very bottom one is not turning It will turn when you start the car. It's the crank pulley. Check and make sure that the very bottom one is not the a/c compressor turn a/c on and check

crank sensor on a 1988 olds. 2.8 v6 should be behind the bottom pulley(harmonic balancer)(crankshaft pulley).You will have to remove the bolt in the pulley first,to do this.You will have to remove the

...cyl with ac...... start at crank pulley rib side around p/s pulley to alt pulley flat side on the left side of water pump then rib side around ac pulley flat side around tension pulley back to ...

Usually located near the crank pulley behind or under it. Disconnect wires if possible and use a socket to get it out. The crank sensor sends the power to the coil. Good luck cheers from Nova Scotia!

...pulley bolt and turn clockwise. If you cannot turn the crankshaft with a wrench easily, then the starter can't either. Turn the crank all the way around to check for something preventing cranking. Is ...