...crank pulley as possible. Turn the crank shaft manually with a half inch ratchet and socket. The belt will, with some elbow grease slowly work it's way onto the pulley. You can also use a dish rag or ...
...crank pulley and replaced it with the new one in the same position, now the car will not start...any ideas as to why? you dont really need to mark your pulley. You need to set your crank pulley to 0 ...
I want to replace Head Gascet, but have to remove Cam chain. How can I do it? I also want to remove Crank Pully. Bolt very tight. Crank Pulleys are generally removed with an impact wrench connected to
...crank pulley and then pulled the AC compressor up as high as I could. Then I could slip the belt on. Little note here, because the belt was so tight the compressor wouldnt slip back into position. I ...
...can hear my A/C working but no air is blowing. When my AC does work, it is very loud. Today when I cranked my engine, my AC was abnormally loud in trying to produce air, then the car shut off and
Question about 2004 3
...pulley , it seems stuck on the crank and wont move , the front pulley is off already , i am from south africa The timing belt pulley is held on by the Centre crankshaft bolt and slides on with a key ...
Question about 2005 3
...crank pulley and sensor off of a motor that has a 2 prong sensor? It is a 2005 Mazda 3 with a 2.3 motor. The new motor has no pulse at injectors. It won't start and the tach doesn't move when turning ...
Usually answered in minutes!
464 Questions
375 Questions
370 Questions
157 Questions
30 Questions