Questions & Answers for: Jeep Grand Cherokee 1 6 crank pulley

...crank pulley, backside of belt around water pump pulley. Tension is adjusted by loosening p/s pump and turning long bolt under it, then locking it in place. Run and check for tension after about a ...

...the outside of power steering pulley,under idler,over a/c comp,around alternator,over fan pulley, around crank pulley, over water pump. The backside of the belt contacts the idler, fan and water

...other than perfectly circular. Any pulley that doesn't spin freely or you are able to move side to side or in and out needs to be replaced. I hope this helps. Check for a bad crank damper

...crank pulley mark with the "zero" (Number one piston should be all of the way up) If you don't feel air, turn the crank all around once more. Once this is done, remove the distributor cap and make ...

...pump, and goes around a few idlers. and around crank pulley that is in front of harmonic balancer. Did the belt fall off? is the pulley missing? cause it should be very self explanatory and

...crank pulley 'till the timing mark aligns with the "0" on the timing scale. Don't turn the crankshaft again. When you are ready to install the chain, locate the mark on the crank gear and ...

...tight and when I look at bottom pulley with car running dosnt look right looks out of Balance? remove the lower pulley (crank pulley and balancer assembly) and inspect it. if any problems replace

check engine light how to open the crank pulley bolt in the center and a special tool removes the pulley

...crank pulley and off water pump/fan pulley. The wp/fan pulley does seem to wobble and when checked moves side to side. There was a squealing sound prior to belt being replaced. Belt just slipped off ...

...crank shaft pulley its harder to turn, like a 150hp lawn mower engine would be. so if PS /AC and alt are seized, then they ARE. id bet not. take the belt off and do it again. btw the one sparking ...