2002 1.6 litre, remove crank pulley bolt for timing belt replacement. clock wise or counter clock wise to remove bolt. counter clockwise
...crank pulley. The inside pulley I am running my water pump and my alt. The outside crank pulley line up with the a/c and power steering but the belt hits my water pump bolts. I have a lower tension ...
...crank it over like 2 times put the breaker bar on the pulley with the handle of the breaker bar touching the ground and u crank it and it'll break free you are going to need a good air operated 1/2" ...
...gsi 1.6 engine and have a blue spark with a snapping sound on the outer edge of the crankcase drive pulley that is the magnetic pick up for the crank sensor. It may have a crack in it making that ...
crank pulley is lined up with the top dead center mark. The make sure the crankshaft is lined up with its mark. Its easier if you can line the marks up before you take the old belt and try not to move
...crank shaft position sensor located ? Its on the bottom front of engine derictly behind the lower pulley at the vary front of the oil pan it goes into the crankshaft on passangers side of vehicle if ...
need to locate crank sensor It is behind the crank shaft pulley in front of the motor.
Question about 2002 Accent
h my name is carl my 2002 Hyundai accent will crank over everything comes on but wont start there's no spark,and no power to fuel pump and i changed the crank shaft position sensor and still nothi
Question about 2006 Accent
...crank pulley at TDC does not necessarily ensure that ignition timing is correct. use a timing light, (if you can get one) to confirm this. typically, inspect the pulley and ensure that the marks on ...
crank pulley bold spanner Removing the engine crank pulley bolt requires a high amount of applied torque and often results in turning the engine before the bolt can be loosened. The safest way to keep
Usually answered in minutes!
1,131 Questions
1,082 Questions
1,047 Questions
517 Questions
500 Questions
