Questions & Answers for: Dodge Stealth 1 6 crank pulley

torque spec for 1993 stealth RT front crankshaft pulley bolt There is a large bolt which is used to attach the harmonic balancer to the crankshaft on a 1993 Dodge Stealth DOHC (non-turbo) . The RT ...

Ad

...crank pulley. it will move the pulley down and loosen the tension. the power steering belt is loosened by a 14mm bolt on a bracket up and to the left of the crank pulley its a very unique bolt not ...

Ad

...sounds good but after a few minutes it starts knocking could that be a knock senser plus where the crank shaft end there seems two be a place on the passengers side were its zipped tyed and you ...

...crank pulley/harmonic balancer. I hope this may have assited you. If you in need of further info or images please send a note back. Best regards, Tom hi i need help i just changed my clutch and ...

Question about 1993 Stealth

2 Answers

tighten serpitine belt if your belts loose it probably needs replacing.theres a tensioner pulley on those that automatically tighten as it stretches.unless your tensioner pulleyis getting weak which ...

timing belt alighnment marks for a 1992 stealth rt twin turbo There are two, whichever is on the head is what determines the mark on the pulley. I think one is a box, and you have 2 lines to line up ...

...Turbo. It won't start. It only gets fire on one coil. All teh coils are good fule pump works, New crank sensor, New spark plugs and wires, motor been port and pollished so motor is good. Any one ...

Question about 1992 Stealth

2 Answers

i keep putting new power steering belts on my car but it just throws them off and cuts my car off because its connected to the alternator. if your car is throwing the belt off it can only be one of ...

...is showing low oil level during idling. It shuts the engine off and after a few minutes it will crank back up. it does smoke some after cranking then clears up. the oil pump start to failor the ...

...pulley it the tdc mark and the piston position are not correct , that would indicate that the harmonic balancer needs replacing however when replacing the belts always go of the timing marks on the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...