Questions & Answers for: Buick Rendezvous 1 6 crank pulley

Crank Sensor Disconnect the negative battery cable. Remove the serpentine belt from the crankshaft pulley. Raise and support the vehicle safely. Remove the crankshaft harmonic balancer retaining bolt,

crank pulley any sugestions This sounds like a bad crank pulley or the wrong pulley was installed or installed incorrect, you will need to remove the belt and check the alignment of the pulleys, check

...crank pulley on the front of the engine. The 7X crank sensor is located about in the middle of the block on the backside of the motor. The side closest to the firewall. Let me know if you have any ...

...crank shaft, where the big pulley at the bottom of engine is that runs the belts, i assume u have gotten a code for it, and that u are a bit of a novice asking this question, i suggest going to auto ...

crank pulley and one in the block the one in the block is on the firewall side in between the transmission and the block. There is a wiring harness for this that runs under the oil pan. Follow that to

What is the best way to get to the One behind the crank pulley and one in the block the one in the block is on the firewall side in between the transmission and the block. So what's the question?

crank sensor . then go to (cam sensor ) if you want more info on it, I REALLY hope this helped you if so let me know . Woody Remove belt then remove power steering pump three 13mm or 10mm bolts get to

...pulley to bypass air conditioner. Started up nicely after all the work was completed, I went for a 20 minute drive and turned off the engine. I tried to start the vehicle shortly after it turns over ...

...bar on the crank shaft bolt. (lowest pulley on the engine) turn it clockwise. If it doesn't move, turn it counter clockwise. If it does or doesn't move(bolt breaks loose), then engine is