Questions & Answers for: Buick Park Avenue 1 6 crank pulley

Question about 1996 Park Avenue

1 Answer

...step?? Can I remove this crank sensor somehow without taking the damper pulley off?? no the damper is part of your crank trigger. you can try to heat the bolt then try to take it off. good luck.

Ad

starter turns motor but crank pulley dont turn pulleys wont turn The balancer and key needs to be replaced. It probably came loose and sheared the key. Check for damage to the crank key way too.

Ad

crank pulley, which I believe drives the belt. The pulley at the water pump, however, is wobley, but it does turn. I was thinking about replacing the belt, and putting coolant in it. What do you think

Question about 1995 Park Avenue

2 Answers

...crank. You may be asking what the difference is between an idler pulley and a tensioner pulley. If so, the difference is: the tensioner is spring loaded and the idler is held in place a bolt and just ...

Question about 1991 Park Avenue

1 Answer

...the crank shaft sinsor located? where is the crank shaft sinsor located in the engine? just beside the lower crankshaft pulley. The crank pulley aka. balancer will have to come off to replace

Question about 1998 Park Avenue

1 Answer

...crank pulley. It is attached to the crank shaft. It has two parts, an inner and an outer that are joined together with a rubber isolator. Over time the rubber breaks down and the inner part part of ...

...pulley traveles 180 degrees and makes a knocking noise center bolton crank does not rotate when this is moved by hand , whats up? 1995 buick park ave. The outer ring should not move independently of ...

Question about 1995 Park Avenue

1 Answer

crank pulley , do i have to remove the crank pulley to access the water pump Remove the bolt for the crank pulley. Use a gear puller the remove the pulley. If you don't have an impact gun, you have to

Question about 1998 Park Avenue

1 Answer

...the crank & has jaws that fit the pulley spokes Have to buy the correct tools (puller & installer) Check out the tools avail online to see what is needed Try You Tube Video to watch ...

Question about 1994 Park Avenue

1 Answer

...crank pulley which caused it to come apart and loose the tooth ring and hinder the crank position sensor which is needed for the ECU to calculate when it needs to fire the plugs. I've seen this time ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...