...crank pulley remover, you'll see three little holes inside the groevs at front side of pulley and there is where you install the bolts I have 3 holes non are threaded and they are small rectangle ...
...side wheel and inner fender to access the crank pulley,After you have taken off your drive belt,take the bolt out of the crank pulley and remove it.now you can remove the harmonic balancer.Good
...signals to engine module to give spark, make sure security system light is not on, the crank sensor sits on the main crank pulley, you may have to remove pulley to replace it, google
...crank shaft pulley. Check the wiring where it leaves the sensor and goes up near the alternator. On this year car its possible a small rock may have gotten thrown up from the road nd got into the ...
Where can I find the"Crank Where can I find the"Crank Position Switch" on a 1994 Buick LeSabre? Thank you. Just off the crank pulley, very hard to get at, remove the inner fender to service
...crank To clarify, if the engine cranks or turns over but won't start, look for a stuck pulley on the engine. You may be hearing the belt slipping on that pulley. Take the belt off and ...
knocking sound coming from bottom puley what is the bottom pulley called There are two on the bottom. One is the a/c pulley and the other is the crank pulley.
Question about 1994 LeSabre
...a1994 buick lesabra coilpacks stick you finger in the hole where the oil fill is and have someone crank it over you should be able to feel the rocker arms move then if its moving check the crank ...
how do i find the crank sensor on the side of crankcase pulley or damper pulley
...crank pulley on the 3.8 liter. The crank pulley must first be removed. A 15/16" socket, three very long 8 x 1.0 bolts (pretty sure that is the size, some large washers, and a crank pulley pulley will ...
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
904 Questions
897 Questions
