...crank pulley. The inside pulley I am running my water pump and my alt. The outside crank pulley line up with the a/c and power steering but the belt hits my water pump bolts. I have a lower tension ...
...pulley bolt [2] . Tightening torque: 170-180 Nm 7 is timing mark on cam,pin mark to top,hole in spoke below pin mark lines up with mark on head 6 is crank timing mark,pin mark on crank lines up with ...
crank pulley is lined up with the top dead center mark. The make sure the crankshaft is lined up with its mark. Its easier if you can line the marks up before you take the old belt and try not to move
crank pulley" and says the entire rubber gasket stripped and I'm lucky I didn't lose all power as everything runs off this belt!!! Car has 38,000 miles - I was 200 miles from home [in upstate NY] &
crank pulley and water pump pulley and the timing belt cover... the belt isnt broke but the idler pulley or the oil pump sprocket is loose and the belt is not tight on that side of the motor... when i
...pulley bolt [2] . Tightening torque: 170-180 Nm (7) is timing mark on cam,pin mark to top,hole in spoke below pin mark lines up with mark on head (6) is crank timing mark,pin mark on crank lines up ...
...crank pulley on a buddy's 2003 Hyindai Tiburon. I got the one middle bolt removed and I tried using my claw type puller and as I was cranking on that the cam timing sprocket was coming out as well. I ...
crank shaft pulley feel loose? I recently have gone through 3 steering wheel belts. I assumed the first belt frayed because it was old and brittle. The new belt frayed within a few days. While putting
Question about 2002 Santa Fe
...crank pulley, because they were damaged, since then, the hydraulic system make a horrible noise, I was thinking that the problem was a high pressure hose near to the rudder steering, but the hose its ...
Usually answered in minutes!
1,503 Questions
1,180 Questions
1,131 Questions
1,254 Questions
1,082 Questions