dont know where knock sensor goes on 1999mercuary villager sensor is located on the head. I believe you will need to remove the intake to get at it.
...relay orbreaker that controls the driver seat only the passenger seat is manual,I have been trying for 3 hours and now to find out where the relay fuse or breaker location and the 1999 Mercury ...
...the nork sensor on mercury villager 1999 van, located? i dont know if i gat d right spelling. nork or nock sensor. the knock sensor is under intake, must remove intake and it is under two coolant ...
...mercury villager located? It is under the lower intake manifold in the valley of the engine.You must remove the cross over coolant tube to gain access to the knock sensor. It bolts into the cylinder ...
where is the knock sensor located for a 99 mercury villager don't worry and DO NOT replace it. It does nothing. http://groups.yahoo.com/group/villagerquest/
...sensor on 1999 mercury villager DO NOT EVER CHANGE A KNOCK SENSOR, just a waste of $600. Ignore KS codes, always. will not harm or help engine. go here
1999 mercury villager,replaced knock sensor,ses light comes on.whats wrong? never, ever replace a knock sensor, it is meaningless and will do nothing to make van run better or worse. go here, join ...
...mercury villager runs fine when first started in the morning but after several miles stats bucking and knocking worse when you try to excelorate bogs down real bad, could this be the knock sensor no ...
1999 mercury villager, where is the cam sensor located and how do i change it? cam sensor is in distributor, not serviceable. 1999 is noted for failing cam sensors. Usually runs good cold, then gets ...
Question about 1999 Villager
Mercury Villager runs rough for about ten minutes then shuts off Engine code po 301 and knock sensor code A knock sensor code will not cause a shut down. dp not replace it. It is a false signal and it
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions