Questions & Answers for: 1999 dodge intrepid problems

...1999 Dodge Intrepid? Location of oil sending unit on a 1999 Dodge Intrepid. Oil light stays on and I need to change this unit to see if that is the problem or the oil pump. Thanks I think it on the ...

1999 dodge intrepid but sometime does'nt want to start I can have runing like for 2 or 3 days fine but like I said sometime does'nt start when it does not start I just live the car like for 2 hour and

...1999 dodge intrepid the i replaced the drivers side power window regulator and switch everything worked for a while then the windows stopped working again also the turn signals, heater blower,are not ...

1999 intrepid will start fine and run ok then will stall. Wont start for a while sometimes for a couple of hours. Is it the ignition switch, starter, cam sensor, or crank sensor? problem is absolutely

...1999 dodge intrepid can i fix antitheft myself on my 1999 dodge intrepid Not unless you are a CHrysler tech with access to scan tools, DBRIII, is the one to use, its all part of the screem module, ...

1999 dodge intrepid my 1999 dodge intrepid car alarm goes off and it shut down my whole car.The car wont start and the alarm wont shut off...what can i do? If it is an after market, you need to have ...

...1999 intrepid free owners manual Problem car turn over but wont start as well when i have the radio and heat working just the heat works but not the radio My motor(2.7) in my 99 dodge intrepid keeps ...

1999 Intrepid with sludge problems. Can I get by 1999 Intrepid with sludge problems, tensoner is plugged. Can I get by with replacing the tensioner and using synthetic oil? Car still runs but not ...

...1999 Dodge Intrepid 2.7 V6 DOHC Problem codes came up after check engine light came on: P1684 P0340 What are they? the1684 is letting you know battery was recently disconnected. 0340 is camshaft ...

...1999 2.7 liter motor from a dodge intrepid fit in a 2002 dodge intrepid that has a 2.7 liter motor are they the same yes the engine is the same but you will probably have to use the enginge wiring ...