Questions & Answers for: 1999 dodge intrepid crank sensor location

...dodge intrepid 1999 motor 2.7 it cam sensor is on the driver side, front of the motor, just below the valve covers in easy veiw, just outboard of the water temp sensor and they both share the same ...

...dodge intrepid i need help locating the speed sensor A for my 99 dodge intrepid...is that the outgoing or the input speed sensor The "Vehicle Speed Sensor" signal is generated by the transmisson ...

...1999 Dodge Intrepid 2.7 engine. Thanks Terry Baker Hey Terry, You're camshaft positioning sensor wil be located on the end of your valve cover on the oposite end of the pulleys and gears. Look for ...

...you have. The cam sensor is located on the left cylinder head. The crank sensor is on the right side of the block. The location will vary alittle with the 2.7 or the 3.2, but in the same general

...shut off while driving and will not start, fuel pump seems to be working. ignitor, coil unit, or crank sensor may be faulty. the crank sensor is located near or behind the main lower engine

1999 Intrepid with a 2.7 engine dies after driving 15 miles. pull over and it starts right up and runs fine again This Symptom (WITHOUT)> Check Engine Light on Is indicative of a FUEL PUMP ...

...crank sensor is located on the pass. side attached to the transmission bell houseing with i 10 mm. bolt and a 3 wire connector. ramundoo The crankshaft sensor is on the passenger side, in the ...

...OF THE CAM SENSOR AND CRANK SENSOR ON MY 1999 DODGE INTREPID 2.7 LITER Cam sensor is right in front under the planum and crank sensor is by the crank harmonic balancer pully. But why do you

crank sensor on the right side (passenger) just on the back side of the seam between the engine and the transmission where the flex plate that connects them is located. It is just above the surface of

Position of crank sensor Do you mean the "location" of the crankshaft position sensor?  If so, it is located on the right rear of the engine/transmission housing area.