Questions & Answers for: 1997 10 egr valve

...10 mph or so car stalls. Also the pick up power it's not like what should be If your check engine is not on, check for a vacuum leak by listening for hissing; check your pcv valve (replace it for 3 ...

...EGR valve it have electric plug and no hoses and clean it. The light did not turn off. You have to reset the computer. Either disconnect you negative battery cable for 10 minutes, or use a scanner to ...

...10 mm bolts securing the egr valve to the intake manifold. -Using the extension helps, since it's a tight area to work in. Makes the removal and installation so much easier. -Be careful not to ruin ...

egr valve and cleaning the inside with carburetor cleaner. try to get the valve to open and close like it was made to do. then reinstall and disconnect the battery for 10 mins. and try to star the car

...1997 mercury mountaineer 5 liter. egr system not a dpfe system, no egr tube, ports into the intake elbow. replaced egr valve egr postion sensor, checked the egr selonoid for resitance showed 30 ohms. ...

...1997 aston martin db7 All engine parts for the 6 cyl are Jaguar 3.2 parts, so any XJ6 or XJS parts. Not to mention the fact that they are 10% of the price! Ditto suspension parts. If anyone tells you ...

...egr and allow the seafoam to set for about 10 min. take off neg cable about 10 min. to reset ecm thin start and drive to see if code come up again. on scale 1-10 removal is about 10 if you have to ...

...10 to push through the tubes to remove the carbon build up. It really is a matter of time. The most difficult thing about changing an EGR valve is getting the flare nut(s) loose. Thanks for using ...

WHAT SIZE WRENCH DO I NEED TO TAKE OFF THE EGR VALVE OF A 1997 NISSAN PICK-UP START FROM 10 METRIC SOCKET UP TO 13 METRIC EGR VALVE BOLTS NOT LARGE BOLTS.

1997 S-10 4.3 runs & drives great until it warms up them when I press down gas pedal it dies out & leaves a smell of turpintine or bad gas. Help possibly stuck egr valve or bad purge cannistor ...