Questions & Answers for: 1996 cherokee dash lights

1996 Cherokee Headlights, brake lights and hazards work fine. I understand this is a fuse, but I cannot find the diagram to replace? I looked in a Haynes manual and it showed a 20 amp fuse controlling

...brake. 1996 jeep cherokee 4x4 When I step on the brakes the parking lights come on and the dash board lights dim. Please help me with this problem so I can get it fixed. bad earth? check trailer ...

...1996 jeep cherokee wont light I have a 1996 jeep cherokee country. The lights for the dash and shifter do not light however the turn signals do. what fuse number controls these lights Hello and ...

1996 jeep cherokee tail lights and dash lights out think its a fuse but no manual to tell me which fuse it is most of the fuse diagrams can be found on the back of the fuse cover when you pop it off ...

...1996 two door Jeep cherokee se, No front Parking Lights I have a 1996 two door Jeep cherokee se, the nose was damaged recently and the right front lights were smashed, I have replaced all parts and ...

1996 Jeep Cherokee Sport. Previous owner states that the dash lights went out after new radio was installed. I had the whole dash open and checked all the wiring which appears to be good. Fuse is good

...is no power to either side of that one Also check brake switch adjustment, it is the interrupter. 1996 Jeep Grand Cherokee cluster meter engine check light not coming and veh not starting pls ...

1996 Jeep 4.0 GC, will not start. Engine will crank, will not fire, no dash check lights. Sounds like your ECM is bad, if you have no check engine light on your dash when trying to start. Have it ...

1996 no tail lights not much to go on here, but check the fuse. and the bulbs. does your dash lights illuminate or is it just the rear lights that are out? If none of the parking lights come on (front

...1996 Jeep Grand Cherokee Replaced headlight switch no luck all fuses are good too Running / Park Lamps are controlled by a BCM body control module and park lamp relay ,located in the junction block . ...