Questions & Answers for: 1995 250 check engine light

250 4.9 engine recently replace bad parts that caused check engine light to come on. water temp gauge become bad. replaced sender,pig tail thermostat 3 times. no change on gauge. replaced with numeric

...250 its 95 only the symtoms are cold days turn key get all dash iliminations exeptt check engine light eventually you her the to relays mounted next to your battery start clicking and if you watch ...

1995 F-250 runs rough It will run rough, clear up and run rough again. No power when it is running roughly and full power again during the normal running time. The check engine light comes on during ...

Check the side stand kill switch. It kills the engine so that you don?t start out with the side stand down. If broken or out of adjustment, it would kill the spark. Check for a broken wire at the side

...1995 Suzuki GSF 250 Bandit. I reconnected the battery after not starting the bike for about a month and the electric start button doesn't work (it was working fine the last time i rode the bike). The ...

...250 diesel. keeps blowing fuse #22,glow plug controller. what might be the problem You should start with the glow plug relay/timer.Check it to see if may be shorted.Remove the smaller wires going to ...

...250 miles: (Every Week) Check Automatic Transmission Fluid Level. Check Battery Electrolyte Level, Post and Cable Connections Check Brake Fluid Level. Check Engine Oil Level. Check Engine Coolant ...

...check engine light flashing is indicating an engine misfire. This could be most commonly caused by a bad spark plug, bad ignition wires, bad ignition coil, bad fuel injector. If the spark plugs have ...

...1995 f-250 4X4 460 engine and the brake lights will not go off, i took the multi switch out and apart then put it back together. it worked for a day or so and now back to the same. if i take fuse # 8 ...

1995 f-250 runs great then check engine light comes on and the truck losses power if i turn truck off it runs fine again I would suggest you try to use a code reader from an autozone or o'rielly auto ...