...high beam will not stay on I replace the light and the turn signal switch and the high beam still would not stay on.. I also remove and ck the relays under the ash tray and it still does not work.. ...
No High Beam but have Low Beam I have no High nut have Low only. Changed Bulbs and Fuses on my 1999 Camry but still does not work on High Beam. When switch is flipped on have no lights at all. that is
...Toyota Camry, High beams are fine but l right low beam doesnt work. Is this a bulb or fuse issue or even something else? yes you are right it is the blub that need to be relace one solution is check ...
Question about 1987 Land Cruiser
1987 Toyota land cruiser wont turn on. Is this a fuse problem? If so where is the corresponding fuse/fuse-box located? I've already look on the und The headlights and high-beam search lights on my
Question about 1987 MR2
1987 mr2 headlights? everytime i try to turn on my headlights, my hazard lights stays on and when i turn on the high beam it makes a buzzing noise yet no light is showing. Check the earth wires at the
high beam goes off. On my Toyota Highlander, if it's in the AUTOMATIC mode, the high beams only stay on while the arm is held up. If I put the light switch in the ON position it works correctly when I
Question about 2002 Outback
Toyota Tacoma truck 1997 -headlight switch will no stay on high beam It will flash and hold on high beam if the switch is on low beam but will not push onto high beam - lights just go out Bad switch ...
...high beams work R and lft fuses are good. Relay is good. Relay clicks whin i turn on low beams Hi and low beams run on different fuses too. Check the low beam fuse. There might be a grounding strap ...
...high beams work Both rt and lft headlight fuses are good. Relay as good,switched with fan relay. Relay still clicks and running lights come on when switch to low beams still no low beams. low beam ...
Question about 1987 Cressida
1987 toyota cressida headlight lowbeams dont come on, but will come on when you "flash" the highbeam. Ive checked fuses, relays, changed stalk all still the same. Any help will do please High beam and
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions