Questions & Answers for: 1500 vac

Question about 2007 Ram 1500 Quad Cab Sport

1 Answer

4x4 will not engage. If front differential is messed up the front end wouldnt move at all correct?- if the frt axle is vacuum actuated it can be either a broken vac line or the vac switch on the ...

Ad

Question about 2005 Silverado 1500 2WD

1 Answer

...1500 rpms, engine shut off when applying brake, turn a/c on or when driving down road and stop, the rpms drops and engine shuts off. Or if idling and you rev up engine the rpms will drop and engine ...

Ad

Question about 1999 Ram

2 Answers

...and vac motor for binging 1998 dodge 1500 4 wheel drive will not pull in any gear 2 w or 4 w drive line good put in any gear trys to pull but pop out took back drive shaft ingage transfer still no ...

Question about 2001 Ram 1500 Truck 2WD

1 Answer

...1500 P/UP , 135,000 MILES. I'VE RECHARGED THE AC USING R134a . WHILE THE AC FEELS COOL ON THE DRIVERS SIDE OF THE CAB THE TEMP ON THE PASSENGER SIDE IS MUCH WARMER AND DOESN'T BLOW SO HARD. CAN ...

...1500 rpm - 2000 rpm it misses. Driving or sitting. i pulled the heads had them checked, reassembled and still have the same problem. Wires, plugs, and rotor have all been changed. try pullingthe vac. ...

fan stopped blowing, h/vac fuse was intact; air fan stopped blowing, h/vac fuse was intact Your fan motor may have failed. The other option would be the high blow relay or the resistor unit. I hope ...

TRUCK IS HARD TO START AND SOMETIMES SPUTTERS WHEN I ACCELERATE , I CHANGED FUEL PUMP ABOUT A YEAR AGO AND RECENTLY CHANGED FUEL FILTER possible fuel reg on fuel rail one of the ways to tell but not ...

1500. during acceleration the air will divert from the dash vents to the defroster vents. when i let up, it goes back to the dash. any ideas? You have a vacuum leak or the little valve in the vac line

When I accelerate the fan quits blowing on my 96 dodge truck. When I let off the gas the blower starts to work again. Are you sure its not a vac leak ? The blower may be running, but if you loose vac ...

Question about 2001 626

1 Answer

1500 rpm. The idle speed is not supposed to be adjustable. It is controlled by the computer. What you may have is a vac leak, or the throttle cable may not be adjusted correctly. If the throttle plate

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...