...700±50 rpm (in ?P? or ?N? position) ' GO TO 6. 6 CHECK TARGET IDLE SPEED 1. Turn off engine and connect throttle position sensor harness connector. 2. Start and rev engine (2,000 to 3,000 rpm) 2 ...
...700-800 rpm in PARK (P) or NEUTRAL (N) position. NOTE: Make sure that the timing pointer is pointing to the 15° Before Top Dead Center (BTDC) mark on the crankshaft pulley. Each notch on the ...
...timing. Firing order is 1-6 counter clockwise and the engine is Front pass side 1-3-5 drivers 2-4-6. Timing is 13-17 @ 700-800 rpm for manual trans and same for automatic (in neutral) Hope this
...700 rpm or so for about 25 seconds, rev the engine a few times and then let it return to idle. 13) Shut the car down. You car has now relearned the new air volume, which should be different than it ...
700 dollars depending on the size and model. Usually you change a water pump when doing a timing belt, because your already in there, and it is a lot of work Personally, I would not spend the money on
...13 - 17 DEGREES BTDC AT 650 - 750 RPMS. YOU NEED A TIMING LIGHT.TO SET TIMING FIRST CHECK FOR ANY TROUBLES.MAKE SURE YOU HAVE NO CODES. NOW TO SET TIMING.APPLY PARKING BRAKE AND BE SURE THAT THE CAR ...
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,309 Questions
1,122 Questions
1,306 Questions