Questions & Answers for: 12v tv

...with my tv and just use a 12v feed direct from my battery to the tv ? Read any information on the 240v to 12v adaptor. If the 12v is DC yes you can use the Battery direct. If it is 12ac no can do. ...

...that it is anywhere near filtered and stable, so most likely you would smoke the TV. Hooking the TV directly to a 12V battery is just fine, as long as the battery has enough current to run the

...12v to TV chassis. When a load is present on the power supply the 12v has a heavy voltage drop down to 2.01v but off-load its back to the 12v, the 24V has no voltage either way. The capacitors had ...

can i connect my tele in mt caravan on 12v Yes. Either by using a 12v dc tv, or if it uses 120v/240v ac by using an inverter on the 12v dc supply which ups the voltage and converts to ac.

...tv. tried 12v with 300 ma no good, tried 12V with 850ma still no go. can't find what the ma is suppose to be. Thise are way too low for the TV to operate amperage wise. Your best bet is to go to ...

...tv was not comming on and the fuse on the t-con board was open.Now, the 12v 5v on psu and mainboard are present after the rely clicks using the remote only if the Vs pin on the connector of the t-con ...

...12v 4A adaptor cable to fit Digitor TV model G9433 or a replacement available, if so where? need a new 12v 4A power adaptor Search on amazon. Don't know your location, but example is below: High ...

...12V. No red light on TV saying it has power although just purchased a new 12v regulated power lead. The red light on the power lead comes on suggesting it is supplying 12v. Is there a fuse in the TV ...

...TV model is LG 42LN5300-UB I checked the voltages coming from the power supply board and got these readings from top to bottom: GND=0, 12v=12v, 12v=12v, GND=0, 24v=21v, GND=0, 3.5V= 3.3v, 3.5v=3.3v, ...

...12v akura tv repairable Hope you can help or advise me I have a 12v tv which came with 12v cigarette supply only. I attempted to wire this direct into my van but to my peril found the wires the wrong ...