Status light does not light anymore - Panasonic ESLA93k Electric Shaver

Thank you for using FixYa. The " control locked " is a safety feature to prevent the inadvertant use of the machine by a child. To unlock the controls press the "end of cycle "button for approximately 3 seconds until the "control locked " indicator light goes out. If you have young children in your home and want to lock the controls press the "end of cycle" button again for three seconds.

Please post if this solution has been helpfull

Thank you

Duncan

You need new battery... they do **** out after so many uses and or time...
Ck

Hi
Your Pot Assembly Unit need Replacing Its Just onder and Attached to your Drive Levers Forward/Reverse.

Gerry.

Hi,
Powerline adapters are generally not durable. You can try to reset the power adapter by pressing the reset button located on the device itself. If it still gives you a red light than call the manufacture and get it replaced.

replace Ballast Board it is what turns Lamp on! Call Encompass 1-800-638-3328 You can somtimes find good deal on Ballast Board at E-Bay

Sounds like you have a bad power supply. In my personal experiences with bad routers they either don't light up at all or all the lights blink. It doesn't take much to send one to the router graveyard. Power surges and lightning strikes are the most common culprits. Hope this helps

try pressing and holding the enter button on the projector for about 30 seconds - this resets it. It worked for me!!

1.       Check the for the Physical connection Between the router and dsl  the  modem

2.       And make the sure the dsl light or the status is solid green in the dsl modem

3.       If the dsl light or link light is bilking on the dsl modem . call your service provided and run a line test to confirm if there is any problem with the telephone line  

Press and hold the power button on the remote control for 10 seconds.