Six (6) blinks on the Timer/Standby led

CK your hori output Transitor and behind it is a blue high voltage capacitor 2k sometimes they will have small burt hole on them ,If it is OK then Replace your STK ICs example STK392-110 Mats has them 1-800-628-1118

hello if you could tell me how many times it blinks i'll try and tell you the fault thanks

shaun

Can be 1 of 2 things. 1st the red tube just needs the voltage to it turned down. In the front of TV (you have to remove the lower front half of TV to access it) is a plastic square with 6 knobs. The from left to right top knobs control focus for blue,green red. The bottom knobs control voltage to each tube in same order (so lower right knob for red) turn SLOWLY to left to reduce voltage until excessive red and lines go away. If you over turn left or right set will turn off. If that does not fix it or if lines reappear then option 2 is that red picture tube is failing outright and needs replacement.

4 LED flashes indicated a faulty IC board

THE LED ON THE FRONT OF THE SET SHOULD BE BLINKING IN A SERIES OF BLINKS THEN PAUSE AND REPEAT THE SEQUENCE. IN ANY CASE IT NEEDS TO BE SERVICED BY A SONY AUTHORIZED SERVICER.

KP46WT510 Shutdown 6 Blinks. 6 Blinks = Low B+ OCP/OVP
SOLUTION: Replaced Flyback transformer. It had no rings on the ringer test.
HQ
Comments: Any load on the B+ line can cause 6 Blinks.
Example: If the 200v line is loaded down will cause a drop in B+ due to bright picture current demand.

Click Here! to download the Sony Kp-46wt510 full service manual.

Hi Yeooow,
I guess you read the fix for my set wth the six-blink error. If not, here's the link:
http://www.fixya.com/support/t647530-tv_couldnt_turn_no_picture
My set is a KP-53HS30, chassis number P65A-A.
I found a bulged capacitor on the "G" power supply board and replaced the components associated with that circuit (6-volt regulator). If your set has the P65A chassis, I'd be happy to e-mail you the service manual I have, if it will help.
-Dan

Sony
Model # KP-53HS10
Serial # 9718217
MFG 2000

Plugged in TV. Timer Standby Light just flashes continusly. No Picture and No Sound.

ITS PROBABLY THE RED PICTURE TUB (CRT). IT LOOKS EASY TO INSTALL, BUT YOU NEED TO MAKE ADJUSTMENTS TO THE SCREEN ONCE IT IS INSTALLED. THE PART IS $3OO. TRY TO FIND SOMEONE TO INSTALL IT FOR $150 OR LESS. HERE IS A WEBSITE TO HELP YOU MAKE ADJUSTMENT IN THE FUTURE ON YOU OWN.

PRIDAH


http://www.somelifeblog.com/2007/06/sony-projection-tv-red-line-repair.html